Take 9% OFF or 11% OFF Your Order (Code: THANKYOU)View Details
Item Discontinued & Out of Stock
Please try related products below.
The ideas are endless when it comes to using the Clipboard DIY Steel Dies from Technique Tuesday on your next project. Made in the USA of high-quality steel, these wafer-thin dies will work in most manual die cutting machines (sold separately) and will cut through a variety of materials. Each package includes...
Full Description & Details
The ideas are endless when it comes to using the Clipboard DIY Steel Dies from Technique Tuesday on your next project. Made in the USA of high-quality steel, these wafer-thin dies will work in most manual die cutting machines (sold separately) and will cut through a variety of materials. Each package includes nine dies that measure approximately .25" x .25" to 3" x 4".
Aren't the check marks going to cut in the wrong direction with that die? The check mark's left side is usually shorter than the right side, but given that the die itself is displaying this characteristic in the photo, that means that once it's used on paper the left side will be longer than the right side.
By: User(12-Feb-15)Helpful Question? Yes | NoThank you!Report Inappropriate
This question has been reported. Thank you!
The cut side is on the underneath. The check marks will be as shown in the photo.
By: Paula K(12-Feb-15)Helpful Answer? Yes | NoThank you!Report Inappropriate
This Answer has been reported. Thank you!
Aren't the check marks going to cut in the wrong direction with that die? 
The cut side is on the underneath. The check marks will be as shown in the photo.